reference numbers inventor 2018

[tripfabio]

Bye to all,
I recently inventor 2018, the problem is that the reference numbers with balls that I used before in the 2015 version at the time of creation there was a sort of snap that helped me to put the line with arrow straight at 45 or 90° now in 2018 this function does not give me and I can not find it in the settings where I can insert it, someone helps me? ?

 

[stefanobruno]

welcome among the users of the latest inventor rel.
among the " remarkable improvements " introduced by rel. 2016 and, given the " notable appreciation ", maintained also in rel. 2018, there is also this beautiful way of procuring disorder in the ball of the masses on the table.
partial recovery of the previous mode, a horizontal or vertical alignment of the arrow lines, you get it holding the ctrl key while placing the ball.
the introduction of new modes in performing the various activities, should always have a way back to the old and experienced system.
first the command was "align " now might call itself " Spread ".

 

[tripfabio]

I must admit that it is quite uncomfortable, moreover when I use the command aligns to align all the balls does not keep the straight lines and therefore you have to do everything manually one by one..... .

 

[stefanobruno]

In fact, with rel. 2016 I no longer used the command " aligns ", it is simply absurd its operating way.
I resigned to have less cured food.