reflection on application options --> sheet

[windreef]

Good morning.
considering that in the file card some paths are managed directly from the inventor project (e.g. folder templates ect) why they are set even by them if they will not be taken into consideration? and it is not possible to work without a set project.
Thank you.

 

[Andrea Scarnecchia]

good morning, in some cases it may be necessary to have part of those always unique paths while working with different project files.
in these situations you typically leave the default option on project files so that to "command" is the inventor option.

 

[windreef]

good morning, in some cases it may be necessary to have part of those always unique paths while working with different project files.
in these situations you typically leave the default option on project files so that to "command" is the inventor option.

I left all default settings, setting each entry in the project file (use different project files) even if then the material libraries and aspects use the same for each project .
I was just wondering how they didn't conflict.
so if I understand your answer well is because always commands the custom project file if the paths are set by project if instead in the project nothing is set then commands the application option.
Thank you very much
It was an athletic doubt I had for a long time, then problems did not give me and so think about working without too many questions.

 

[Andrea Scarnecchia]

I left all default settings, setting each entry in the project file (use different project files) even if then the material libraries and aspects use the same for each project .
I was just wondering how they didn't conflict.
so if I understand your answer well is because always commands the custom project file if the paths are set by project if instead in the project nothing is set then commands the application option.
Thank you very much
It was an athletic doubt I had for a long time, then problems did not give me and so think about working without too many questions.

exact, the project file always commands, but leaving default in the inventor project file will use its application options.