registration bread and separate components

[il_guerriero]

Hello, everyone. Does anyone know the thicknesses that have to have the lines that make up the internal margins and the outer margins of the inscription box (cartiglio)? and those of the separate table components? I'm going crazy because I don't know if they're standardized, and anyway, if they were, I couldn't find anything!
Thank you in advance

 

[Max-C]

Hello, everyone. Does anyone know the thicknesses that have to have the lines that make up the internal margins and the outer margins of the inscription box (cartiglio)? and those of the separate table components? I'm going crazy because I don't know if they're standardized, and anyway, if they were, I couldn't find anything!
Thank you in advance

Bye.
sheet sizes: uni en iso 5457:02
type of lines:uni en iso 128-20:02 uni iso128-24:06
Registration pane: uni en iso 7200:2007
written: uni en iso 3098-0/5:00

search the internet and, above all in the university dispensers, you will find everything:smile:
In fact, those of the rules are always a good search. it would be nice that in the forum there was a topic with the list where everyone can contribute.

 

[il_guerriero]

I thank you... I tried to search everywhere, but the regulations on the cartiglio do not show the thickness that must have the lines that form the chart :frown:

 

[Max-C]

I thank you... I tried to search everywhere, but the regulations on the cartiglio do not show the thickness that must have the lines that form the chart :frown:

simply because there is no dedicated legislation. you can recall the rules that I mentioned above. .

 

[il_guerriero]

ok ok grazie mille!:finger: