Utente NX
Guest
Hi.
if I replace a component with the 'replace component' assembly constraints fail (logical).
I remember that in nx 3 there was the command "assemblies→ components→ define mating alternas " and "assemblies→ components verify " to avoid losing the 'mating condition'.
Is there something like this in nx7 or should I redefine 20 assembly constraints?
if I replace a component with the 'replace component' assembly constraints fail (logical).
I remember that in nx 3 there was the command "assemblies→ components→ define mating alternas " and "assemblies→ components verify " to avoid losing the 'mating condition'.
Is there something like this in nx7 or should I redefine 20 assembly constraints?