citri
Guest
Hello everyone
Can you tell me if there is a chance to replace in a table, the detail I put in?
I practically have the original part.ipt part that I copied and renamed in part-rev01.ipt and to which I made a couple of changes. Since the part is quite complex and I would like to avoid remaking the table, somehow, can I replace in the table the particular part-rev01.ipt to the original part.ipt and maintain, as far as it succeeds inventor, the views and quotas? (in the .iam axieme I had no problem as the constraints were not applied at the points I modified)
Can you tell me if there is a chance to replace in a table, the detail I put in?
I practically have the original part.ipt part that I copied and renamed in part-rev01.ipt and to which I made a couple of changes. Since the part is quite complex and I would like to avoid remaking the table, somehow, can I replace in the table the particular part-rev01.ipt to the original part.ipt and maintain, as far as it succeeds inventor, the views and quotas? (in the .iam axieme I had no problem as the constraints were not applied at the points I modified)
