represent particular in two positions

[rubo825]

I have a problem like this:
I have to put on table two views of a pliers, a view in which the open mobile ganscia is represented, and the other view in which is represented the closed ganascia... in the catproduct muovo the ganascia with a quota... Do I need to use scenarios? How do I do that? Thank you. .

 

[mcbramby]

Yes... you must use the scenarios :smile:

 

[rubo825]

but in the controls of the scenario, I do not find the way to move a piece... You can't see the constraints. .

 

[mcbramby]

you have to move them with the manipulator ................ make some evidence, and you'll see it's simple...... :smile:

 

[rubo825]

you have to move them with the manipulator ................ make some evidence, and you'll see it's simple...... :smile:

but if I move them with the manipulator I will never have a right measure!!! Is there a more precise way?

 

[mcbramby]

create 2 product................

 

[pasticcio75]

you could make the view opener, and then lock the view itself and then change the catproduct and make the view clamp closed. .

Hi.

 

[falonef]

when you create the scenario you have to choose whether it is connected to catproduct or independent.

in the scenario then goes on the constraints and assigned to your liking.

 

[bandy]

for what I have understood, if you use the complete scenario catches "fresh" the situation at the time of creating the scenario.
so with 2 complete scenarios, one closed and one open, you should have a blocked situation.
then then move the constraints as you think the scenarios always remain those.
It is true even if you have to update the scenarios with substantial changes you have to give them back, since I couldn't copy them.