request for information by mould

[monster]

I have a little problem to solve that I don't know how to deal with because it's not part of my mold category.

stamap a rubber bellows ok for the outside but the inner soul like the vent??? Blow daria???? How? ?

with retractable pliers do they exist? ? ?

I ask you an vs opinion to the most experienced.. .

 

[Plus ENGINEERING]

the detail you describe seems more extrusion than molding. therefore it would be to realize a thread and not a mold.
the cost would also be significantly lower.

 

[monster]

lumi please. . .

Well explain to me how it works if you have some files like send me too much I don't have to do anything in question I just wanted to know a way to extract the inner soul

ps we have already contacted you by email once I don't know if you remember...cmq if you want you can follow the tread or via mp...cmq I think it makes pleasure to others hello and thanks

 

[zeigs]

according to me did not consider it pleated

 

[Fabietto]

for the inner part you can make a punch divided into 6 parts + 1 central hazelnut,
type 6 ears + central soul. the central soul must retract before extracting the piece.

then thanks to a bit of tilted planes, t-guides, and delays between the various spikes make in such a way that when the retracted hazel tightens towards the inside 3 alternate spikes, while the other 3 are still.

when the 3 moving spikes created enough space, let the other 3 move. and the game is done.

difficult to explain in words, but both hasco and dme have already some dowels that make these movements. Maybe you can't apply them, but they make you understand the concept. .

 

[monster]

It seems a little expensive to do... having seen the model
in hand and after turning it to see the inside I saw that there were no signs of closure regarding particular movements but it was a unique soul turned with the ridges.. .

 

[PaoloColombani]

I have a little problem to solve that I don't know how to deal with because it's not part of my mold category.

stamap a rubber bellows ok for the outside but the inner soul like the vent??? Blow daria???? How? ?

with retractable pliers do they exist? ? ?

I ask you an vs opinion to the most experienced.. .

I think you answered yourself. If you hold a blind side, with the compressed air the swire from the soul as a sock, the rubber is still hot and this helps you.

 

[monster]

I don't know if it works. . .

 

[Fabietto]

Maybe in the molding phase one side is blind, then it is cut after the molding. .

 

[monster]

no the outer part is made by two cheeks in case both the soul as an extractor pin

or the soul in a wagon if the imprint is obtained from the fixture and the mobile

... there could be so many solutions ....you would like a rubber molder:biggrin: