reverse solidworks model

[AIRBOX27]

hi to all, I wanted to know if it is possible in solidworks to reverse the model, that is to make the full voids and vice versa (i.e. getting the soul of the model in a few words).
thanks to all

 

[meccanicamg]

so on the two feet... You can do it. However, you have to look at whether it is in part mode or in combination mode and use Boolean functions.

have a body or part like a cube and your model. even with the commands of the molds you can make the soul of the model but you have to look good how to do.

 

[Exatem]

all the time after having presented in the appropriate area...

 

[AIRBOX27]

so on the two feet... You can do it. However, you have to look at whether it is in part mode or in combination mode and use Boolean functions.

have a body or part like a cube and your model. even with the commands of the molds you can make the soul of the model but you have to look good how to do.

Hello excuse me though in solidworks where can I find the Boolean functions?

 

[sampom]

Hello excuse me though in solidworks where can I find the Boolean functions?

between the Functions, command Abana.