right bond

[Error404]

Hi, guys.
I have a problem with constraints. I'm designing a cage with two doors on the side. to have the security of the door closure I have inserted an end, which I can not however bind in the right way. I attach screenshots to make me understand better.

-I have inserted a tangency bond with min.0 and a max not defined to make it infinite, in this way when I go to close the door also closes the endrace- when I open the door, the gate does not reopen together.
what bond do I have to give to the end to make so that only during the opening of the door follow him and do not block me the door?the result should be this:

 

[stefanobruno]

Also put an angle bond (flexible) on the wheel lever of the micro that forces it to remain in rest position.

 

[Error404]

Also put an angle bond (flexible) on the wheel lever of the micro that forces it to remain in rest position.

I put flexible assemblies. I gave an angle constraint with a maximum inclination and a minimum to the end arm. If I put the option "use offset as a support position" the shutter pushes me the door.

 

[Zac69]

I put flexible assemblies. I gave an angle constraint with a maximum inclination and a minimum to the end arm. If I put the option "use offset as a support position" the shutter pushes me the door.

I would use the contact group.

 

[Dottingmarcoesposito]

set a proportion!
es.. if the end is moving with a race from 0 to 30 mm.. or from 0 to 60 degrees.. and the lever must go up to 120°.. write a report on the door that moves for example 1.68 degrees compared to the micro. .

 

[Dottingmarcoesposito]

Hi, guys.
I have a problem with constraints. I'm designing a cage with two doors on the side. to have the security of the door closure I have inserted an end, which I can not however bind in the right way. I attach screenshots to make me understand better.

-I have inserted a tangency bond with min.0 and a max not defined to make it infinite, in this way when I go to close the door also closes the endraceView attachment 47430- when I open the door, the gate does not reopen together.
what bond do I have to give to the end to make so that only during the opening of the door follow him and do not block me the door?View attachment 47431the result should be this:View attachment 47432View attachment 47433

...can you just tell me the name to look for to create the appearance of the sheet you posted?

 

[Cast16]

proof qui.

 

[Error404]

...can you just tell me the name to look for to create the appearance of the sheet you posted?

is called *lamiera with rhombus you find it in the library aspects high