rancapas
Guest
good morning to all, premitting that not design in inventor, but always in autocad and then amount the model in inventor to carry out stress analysis,
I have a problem in detecting a share on the deformed piece. the problem is as follows: a customer asks me that by applying a force to a ring, it
must deform a value "x".
attached you will find the image of the result of the analysis, I would need to measure the quota highlighted by the red arrows of the image to check
that the requirement dictated by the customer is respected.
Thank you all in advance.
I have a problem in detecting a share on the deformed piece. the problem is as follows: a customer asks me that by applying a force to a ring, it
must deform a value "x".
attached you will find the image of the result of the analysis, I would need to measure the quota highlighted by the red arrows of the image to check
that the requirement dictated by the customer is respected.
Thank you all in advance.