road design: widenings in curve with autodesk civil 3d

[leonardo1994]

Hi, I would like to submit a question concerning the extensions in curve of lanes for inscribability of vehicles in autodesk civil 3d. the command of the country kit italia returns the polylinee 3d that show in the plant the position that must take the eyelashes in compliance with the dm2001 and the geometric characteristics attributed. While the allocation of enlargement for external eyelashes is immediate, through the imposition of these polylines as a wide objective in the properties of the modeler, I cannot attribute the correct position to the inner eye (half-breeding line) which, as a result of the enlargement calculated, is steeped within the curve. Could someone give me directions on this?
Thank you very much.

 

[Tristan]

question: Have you calculated and applied the elevation? If the answer is yes, you don't need to move the neck along that polyline, since the slope of the lanes will be all uniform, so it is not important, in my opinion, to change its position; If the answer is no, then your question can make sense. and if you move the axis route along the polylinea so you can recalculate it?

 

[Tristan]

even if the user who placed the question disappeared into nothing, probably kidnapped by aliens, complete the answer, if ever it should serve someone.
the ck also installs new subassemblies including "enlargement", realized by a double lane carriage capable of bringing both the eyelashes and the helmet on the planimetric position of the polylines generated by the "enlargement in curve" tool of the country kit, through the objectives of the modeler.