rotation sketch on the plane

[leggera]

Good morning.

I did not understand why the pocket with the working size does not rotate me if I rotate the sleeve.

I proceed in this way to creation.

select the virola where to go to make the processing of size.
seleziono size and I do a sketch as in the image using as piano the sleeve.
I project the geometry of the sleeve diameter and then the function cuts and executes me the size.
until here everything ok, but when I roar the sleeve the plan and the sketch remain fixed.
but what is there any particular function I have activated without notice?

I always worked.

Thank you for your help.

 

[DrBarde]

Did you happen to activate the ''posticipa update'?
in case you also try to regenerate everything.

 

[leggera]

Nothing to do.. .
Usually if the plan is created on a rubbing that rotates behind it.
Boh!

 

[infallibile_GF]

for what I could experience myself sitting standing and standing, I can with absolute certainty state, without fear of being denied that, and here I say it and here I am drowning, in order to obtain the rotation of the hole on the virola, we must first check the option of adactivity of the parts/assieme. if even checking the adactivity options these last properly set appiaiono, the transformation of the axieme containing the problem together welded, improves the adactivity relations, especially if the hole of the virola is executed, not in the part, but as welded axieme processing (mechanical processing, or preparation)
if even after making the above attempts with great clarity, expertise and promptness from undersigned, the problem remains, I would recommend to adopt the clint eastwood method. which method is to bring to the mouth a pencil, cigar, as the well-known Hollywood actor took to the mouth the beloved cigar before a mortal duel, to look at the screen with threatening air and to take it highly of the problem.

 

[leggera]

is not a welded assembly. Besides the virola has the adaptive tick.

 

[DrBarde]

what inventor uses? I tried flying with 2020 and did. at the level of together therefore without activity.

 

[leggera]

2025, but he always did.
I am using a pack & go imported set and while repositioning it with new lanes I remain stuck. I don't understand why I don't see anything strange and the piece is pretty simple.
I'm afraid he's corrupted.

 

[DrBarde]

Unfortunately it has the software '' too new'' and I can't see it. If the procedure, sketches and system is identical to what it usually performs, I'm afraid it's right about the corrupt file.

 

[Peppe]

Good morning.

I did not understand why the pocket with the working size does not rotate me if I rotate the sleeve.

I proceed in this way to creation.

select the virola where to go to make the processing of size.
seleziono size and I do a sketch as in the image using as piano the sleeve.
I project the geometry of the sleeve diameter and then the function cuts and executes me the size.
until here everything ok, but when I roar the sleeve the plan and the sketch remain fixed.
but what is there any particular function I have activated without notice?

I always worked.

Thank you for your help.


View attachment 71730View attachment 71732

you can make a screen by setting yourself up with this command compared to the sleeve?

 

[leggera]

Good morning.

in the end after several losses of time I rebuilt the solid.
the file was corrupt and this new one works.