scale a drawing in the layout with windows

[Dario1982]

Good morning, everyone! I press that I'm new, and I don't know if I'm writing in the right section, in which case I apologize... here is my problem: I have a table, where in the layout there are the usual elements: Cartridge, square and windows. .well,measuring the cartilage is 21 rather than 210, is set in cm instead of in mm.. I would like to enlarge the whole of 10 times, but in doing so, the windows are obviously going to be blessed and I have to reframe them one by one again, give them a ladder etc.. insomma, would come a job too long. Does anyone know if there is any command or system variable that allows me to scale the whole table, including windows, so that the latter "go behind" the rest of the design and are scaled accordingly? Thank you so much!

 

[Tristan]

Have you tried the scale command?
edit: you're right.... windows go to shit. according to me you touch the dear and old elbow oil

 

[smemo]

I recommend downloading "vp outline by timw cab06.lsp" http://www.theswamp.org/index.php?topic=9461.msg129670#msg129670 oppure "vpoutlinev1-0.lsp" http://www.cadtutor.net/forum/showthread.php?21820-modelspace-coordinates-from-paperspace-viewports&p=540937&viewfull=1#post540937 These progrograms create in the model space the contour of the layout windows.
at this point you can redeem other objects and then with the application "managementfl - pagination in the layout cards" http://www.cad3d.it/forum1/showthread.php?18852-gestionefl-impaginazione-nelle-schede-di-layout quickly remake the various windows properly scaled, following the contours of the previous windows that you now have in the model space.

 

[Dario1982]

I recommend downloading "vp outline by timw cab06.lsp" http://www.theswamp.org/index.php?topic=9461.msg129670#msg129670 oppure "vpoutlinev1-0.lsp" http://www.cadtutor.net/forum/showthread.php?21820-modelspace-coordinates-from-paperspace-viewports&p=540937&viewfull=1#post540937 These progrograms create in the model space the contour of the layout windows.
at this point you can redeem other objects and then with the application "managementfl - pagination in the layout cards" http://www.cad3d.it/forum1/showthread.php?18852-gestionefl-impaginazione-nelle-schede-di-layout quickly remake the various windows properly scaled, following the contours of the previous windows that you now have in the model space.

I added this lisp, I didn't know it and it's really convenient! until now, to do the same thing I had to enter every single window (reading to block them first), and I created a rectangle almost coincident with the edge of the window itself..a workmanship. This is much faster and more accurate, thank you so much!