scale feature model solidworks

[MassiVonWeizen]

I attach a simple part that seems to work.
be careful that I noticed that by entering the formula directly into the cell of the scale report this stops working, while connecting the cell to another that contains the formula (so doing read only the value) works.
Meanwhile it starts to give an eye to the file

 

[Hisoka]

First of all, I thank you for the time you are devoting to me
I think I'll have to go on the road that you told me because what I have in mind as you rightly told me, sw doesn't let me do it.

a single small consideration on the design method that I indicated to you
First I do the sketch in 3d because it has a base and a height for extrusion
after which I create the part by binding it to the sketch by doing the procedure that I indicated before because I create 15/20 parts related to the 3d sketch of the axieme
if everything is done well when changing the sketch in the axieme also change all the parts to it tied according to the functions that are set
can be considered as a kind of multibody and together with this are the only two ways I know to be able to modify n° parts simultaneously (15-20 and theoretically infinite)

 

[MassiVonWeizen]

[

First I do the sketch in 3d because it has a base and a height for extrusion

I have not understood how it is done but it is not important.
I use 3D sketch when the geometry of the sketch develops simultaneously on 3 sizes

quotas]This is the only two ways I know to be able to modify n° parts simultaneously (15-20 and theoretically infinite) [/QUOTE]as I have already told you on one side then make 15/20/tenant to the infinite configurations.
If, instead, these parts will have each custom functions, your speech can make sense.