scale problem with restraints

[tatyb295]

good evening, I have a problem with the retino command of autocad... especially with the scale...I would like to use the model ansi21 with the inclined lines, I tried all kinds of scale, from the lower to the highest, but in all cases the filling is not displayed!
I tried with various models, but only with solid obviously I do not match problems.
That's why I thought it was a scale problem!
What's wrong?

 

[MassiVonWeizen]

What does it mean from lower to higher?
the scale you can insert it by hand, you don't have to choose from those proposals from the curtain (which by memory goes from 0.2 to 2 and it's not that much change)
putting an image, attaching a piece of the drawing, helps to understand what situation you are talking about.

It would also be nice to answer the other questions you ask to say whether you solved or not, and not just to expose problems!

 

[tatyb295]

I also tried to put them in hand...I said the highest in the sense that I also chose a very high(type 100)...I was badly expressed!
Sorry if I didn't answer the other post, but it was just because I hadn't solved yet!

 

[MassiVonWeizen]

attach the piece of files that gives you problems.
if there are privacy issues deletes everything else, leave the box to fill, zipper and attach it going in advanced mode of the message.

 

[tatyb295]

I fixed!I set the scale 0.2 and finally managed to view the retino!scusami, but still I am not very familiar with this program!thanks thousand cmq!:wink: