sections

[Giorgio.f]

Good morning to all, I have been following you for more than 3 years, I have to congratulate all the staff for the beautiful community you have created.
now I need your help, I am beginning to use now daily proe (in particular create parametric 2.0) after using only inventor for 5 years.
I find myself in crisis in creating sections, especially non-linear sections or anyway with sketch reference.
Is there anyone who can give me some advice on this?

Thank you.
And he went

 

[tartufon80]

Bye!
try to read This is what?

 

[Giorgio.f]

Bye!
try to read This is what?

Thank you very much! it was very simple.. I was just missing to select the offset section! Coming from inventor I find some little immediate things compared to the old program.

 

[tartufon80]

Don't worry.

used to look for: over the years many historical users have removed from the poop many users, me first, and the history of the discussions is better than any manual!

at first the ptc world seems ostic, but then once used it is a bomb!
Good job!

 

[Giorgio.f]

Don't worry, the search was the first thing I did, I've been coming for 15 years of moderation forum.
Unfortunately I couldn't find the specific discussion, so I thank you again.