series a spirale

[baudi84]

Hello everyone
I would like to make a "spirated" series in the sense of creating a series of a component on a spiral guideline. Can you help me? Thank you.

 

[Tarkus]

Hello everyone
I would like to make a "spirated" series in the sense of creating a series of a component on a spiral guideline. Can you help me? Thank you.

Who are you, where are you from, what are you doing, what inventor do you have? *:mixed
Present!http://www.cad3d.it/forum1/showthread.php?t=132*My advice:write it in profile

 

[Catafratto]

Can you help me?

Yes, but first you show up in the section! :tongue:

I tell you what I did (as always, one of the possible solutions, by experience then always jumps out another better! )
1) I create a piece of support (which you can set hidden in the separate components) that I will use to indicate the trajectory, like a cylinder
2) I make a hole in the cilider where the series starts
3) I make a 3d sketch with the spiral, bound to the axis of the cylinder and the start of the series
4) I make a series of hole processing, leaning on the spiral for trajectory and taking care to expand the series dialog and set direction 1
5) obtained the model with spiral holes with the desired step, constraint my part to that hole
6) I make a component series (together environment) associated with processing.

 

[baudi84]

Thank you1000, I didn't think of it as an associate. (Now that I have presented myself, I am no longer lacking)