series of fill with different sides

[TECNICO]

I hope someone can help me.

I have to make a series of fills of an asola inside a circus sketch.
My problem is that I have to dispose of them with a rhombus or a triangle but these should not have equal sides, is it possible?

 

[Cla]

You could post an image that I didn't understand the problem.. .

 

[TECNICO]

I remember that the version used is the wf2.. I framed in red the fact that I don't want is the same for the sides.

[/URL]

 

[TECNICO]

I attached a zip file with inside the image.
the value 20 as the length of the sides of the roar or square figure is equal for all four sides.I need to have for example a rectangle that is two measures.. is it possible?