sform analysis

[gpg]

Good morning

I've been testing the free version of alibre 12.1 for some time, and I have to say that it will most likely become the cad I'm gonna use for my personal work.
I only have a perplexity about the lack, or at least I have not found it, of a function that allows to control, perhaps with gradients of colors like other sw do, the corners of the surface of the piece; very useful function when designing pieces that must be molded products.
Is there a possibility to insert this function?

thanks for the answers

 

[davide_r]

In addition to the sform angle (draft angle) that is in the dialog box by clicking on the extrusion icon, there is the “loft” function which allows to extrude a form, for example a rectangular or square-based figure, connecting it up to become for example circular, even along a non straight path.

 

[gpg]

thanks to the answer

but I would need a display function that would allow me to check if all surfaces are unformed.

I tried to search in the various forums but so far I found nothing.

 

[Preparation-H]

thanks to the answer

but I would need a display function that would allow me to check if all surfaces are unformed.

I tried to search in the various forums but so far I found nothing.

I don't think the standard version predicts this possibility... Maybe (and I say maybe because I'm not sure) with the model check of algor present in the expert...

Hi.
p-h

 

[gpg]

I tried to document myself on model check, but I don't think it's my case.