sform angle greater than 30° - wf4

[Alberto.E]

Hello, everyone, I'm fighting with the sform. pro-e does not allow me to make sforms greater than 30°. Sure I could get the same result with a sweep or angular bevel but I would like to understand if you can change this limitation from the config pro. Thank you.

 

[maxopus]

I don't think so. I don't think I can change the situation.

 

[Alberto.E]

immaginavo...
surrounding ho trovato questo
http://www.synthx.com/tom/sy_tip_0309.htmin case someone had my own problem.