Stefano_68
Guest
Good morning to all,
I drew a part and got the convex part with the fitting command and the concave by subtracting a cylinder.
what I can't get is the sform on the faces at the two ends (indicated with the red dot and the one on the other side).
I also attached the ipt file.
thank you for the attention, hello
I drew a part and got the convex part with the fitting command and the concave by subtracting a cylinder.
what I can't get is the sform on the faces at the two ends (indicated with the red dot and the one on the other side).
I also attached the ipt file.
thank you for the attention, hello
