shady resolution and draft quality

[tanticapelli]

Bye to all,

based on these tips I found on the net: https://www.linkedin.com/pulse/massimizzare-le-prestazioni-con-grandi-assiemi-senza-fiorettias I can do to lower the "shaded and quality roughness" bar of the axieme (see image) because in my case it is grey and is not editable.
has to do with any setting in the properties of the parts?

I have slow problems and I'm attacking everything to try to improve the situation.

thanks to all

so many hairs

 

[MassiVonWeizen]

I don't know how to tisttivate it and I have no idea how to recreate it on my oc.
However, you can improve the management by disabling the component by dragging (attrbuting a button), removing the translucent selection, displaying as much as possible in shady mode without borders

 

[MassiVonWeizen]

read the guide on quality options

 

[tanticapelli]

read the guide on quality options

thanks massive, I read the guide and I have already unchecked moves the components by dragging and also other options as from your advice mentioned to the old posts.

However I did not find the cause of this "hardening" that is practically the only thing that remained to try to try to have a little more fluidity of operation in the design of the axieme.

thanks the same

so many hairs

 

[MassiVonWeizen]

the guide, you arrive by pressing the ? from the page of the options of the document. at least you have a starting point for research

 

[MassiVonWeizen]

the page is this http://help.solidworks.com/2017/ita...tions_image_quality_display.htm?verredirect=1Is your graphics card certified?
Do you do it with all the asses?
Do you have a lot of underarms? verify that the check is selectable on applies all referencing party documents on all and activate

 

[tanticapelli]

Hello Masses,

yes the card is certified, there are various subaxioms but I have not actually checked the check inside them (after tomorrow if God wants I will). I just looked at the big one.

 

[tanticapelli]

Hi.

I managed to lower the two bars and pounce in all the subaxis but the big set continues to have the bar at the top not editable.

I don't know if it is due to the presence of toolbox elements that are read-only... boh.

so many hairs

 

[MassiVonWeizen]

may depend on the toolbox.
toolboxes slow down a lot, especially if you have pinions.
I suggest you make your own bookcase

 

[tanticapelli]

Okay.

 

[tanticapelli]

at the end to reactivate the bar it was enough to disable the "big axiemi" mode in the larger axieme.. .

better late than ever

Thank you.

so many hairs