sheet metal development on one of the main floors

[Marco105]

Good evening, everyone.

I wanted lumens between the posts

 

[Marco74]

Good evening, everyone.

I wanted lumens between the posts

I don't know sw, but sincerely I didn't understand that lumi you are looking for, to me the question is not clear

 

[MassiVonWeizen]

It seems clear to me that he did not finish the message, nor that he is in a hurry, so he expects. would also be the case that it updated the profile with the version of solidworks.

 

[Marco105]

excuse me...line adsl suddenly ko...the result unfortunately you have seen it.. .

premitting that I use solidworks for a few days. the question that I tried to ask you today is as follows:
I shaped a folded sheet and generated the development with the "flattened" command. the development I obtain does not lie on one of the main plans (the ones present at the top of the operating tree to understand us). This creates complications in the table (for reasons why I don't want to bother you). Is there a way that allows me to achieve development and that this in the environment leaves in one of the main plans?

I hope I could explain.

Thank you! Good evening

 

[MassiVonWeizen]

only if you draw the sheet on one of the above floors.
as alternatives you can:
- create a special view that calls you back to the table
- create a special configuration in which with the commands moves, wheel you combine the sheet to the planes (this obviously only if it does not interfere with the general construction of the part)

Maybe there's something else but now I don't think about it