Climb
Guest
Good morning to all,
I would like to ask if you can get a development (flat model) of the sheet called "lam-sweep" (red) of the attached file.
it is made by a sweep and with successive cuts (in a rather approximate way, I know!) but I would need a development even only similar in dwg to give the laser cut (then in workshop will adapt).
would it be possible somehow? (also starting, I know, from 3d sketches "recalcati" from the piece).
software: inventor pro 2019 (first I used solidworks for a long time and I'm not using sheet modeling)
I tried to find in the old discussions without success. . .
Thank you in advance!
I would like to ask if you can get a development (flat model) of the sheet called "lam-sweep" (red) of the attached file.
it is made by a sweep and with successive cuts (in a rather approximate way, I know!) but I would need a development even only similar in dwg to give the laser cut (then in workshop will adapt).
would it be possible somehow? (also starting, I know, from 3d sketches "recalcati" from the piece).
software: inventor pro 2019 (first I used solidworks for a long time and I'm not using sheet modeling)
I tried to find in the old discussions without success. . .
Thank you in advance!
