sheet metal

[DANI-3D]

Why don't you like this method?

no problem, it depends on the fact that it is a long method because the joint wall command should be done for each single surface, if the piece was more complex you know that boredom:

 

[DANI-3D]

Bye to all,
I attach a sheet that I have made, my problem is that I want to stretch it 300 mm from the straight side, how can I do it? of course without having to remake.... .

another method, with the extended command, a little faster.
greetings

 

[blubossa]

another method, with the extended command, a little faster.
greetings

great..... finally I begin to understand something more about the commands:finger:

Thank you.
bb