sheet metal

[tanticapelli]

Bye to all,

probably banal demand, on a potential sheet and its development.

in the image in example the circled area of red with the two sides "carved" is feasible or not? because the program allows me to do it without giving error messages, but if I am not mistaken developing the sheet I would have the two overlapping plates and the thing seems a little distant from reality.

Thank you.

so many hairs

 

[tanticapelli]

excuse the typing error in the title but I don't know how to correct it.......

 

[xxfast]

It's feasible.

 

[MassiVonWeizen]

It is not that you see very well how the discharges are managed. if done well is feasible

 

[tanticapelli]

Thank you.

So I don't have to worry if in the flat repetition I have an overlapped flap?

in my ignorance it didn't seem possible to get twice the same square from the same piece of sheet (the circled part is that of the previous image "petuta piatmente cazzuiu")

so many hairs

 

[MassiVonWeizen]

It's always worth the usual speech... said and laughed a thousand times... beautiful pictures, but if you attach the file you understand better the situation you can give better advice

 

[MassiVonWeizen]

excuse the typing error in the title but I don't know how to correct it.......

contact the moderator

 

[xxfast]

That's what I meant. . .

View attachment Parte1.rar

 

[tanticapelli]

That's what I meant. . .

View attachment 49242

That's in fact, it's strange, but the software doesn't signal it, it seems like a fairly trivial error, doesn't it?

 

[Mike1967]

That's in fact, it's strange, but the software doesn't signal it, it seems like a fairly trivial error, doesn't it?

verify this...

 

[tanticapelli]

verify this...
View attachment 49243

thanks mike, I checked but the option in question was already disabled. . .