sheet on uncentered table

[MARCOC]

Good morning to all, you never happen to have some tables that do not focus more with the graphic area dpo the optimized zoom command (double clil with the mouse) and as if there was something not visible and not selectable outside of the square.

Can someone tell me if there are ways to figure out what doesn't make it optimize the view?? ? ?

Thank you very much

 

[MassiVonWeizen]

What kind of views?
details? sections? interrupted? Ripped?

 

[drake]

Yes, it depends if in the views there are components that, for example, have sketches that are not hidden. At least this happens to me. So when it bothers me, I see what the sketch is, I have to hide, open the part or the axieme that contains it and hide it. Then everything's normal. If I do not erro, from 2016 there is the zoom command to center the sheet over the optimized zoom. . .

 

[MARCOC]

for boulders, in this case it is a view in section, transported to u sheet other than that where the section depends, but it also happens on sheets where there are seen a little of all types, sections detail split etc...

for drake, that of hiding the sketches already noticed even I if there the sketch displayed in the model the view considers it, but in this case and others I do not have visible sketches and the sheet remains scented.

the command you say drake there, but now I needed to understand what remains tied to the views that don't make me center her

 

[MassiVonWeizen]

if you can attach a drawing because it is not easy to understand and give directions to feeling

 

[MassiVonWeizen]

verify that during the insertion of notes, tables, sketches was not activated that view.

 

[MARCOC]

the file I see to post it, but first I have to remove headers and stuff varies to make it anonymous

What do you mean by active? ? ?

 

[MassiVonWeizen]

the correct definition is lock/unlock the view in the foreground

 

[MassiVonWeizen]

the file I see to post it, but first I have to remove headers and stuff varies to make it anonymous

delete the sheet, clean the block tag if there were, delete the design and part properties and you should be placed