Paolodm
Guest
Bye to all,
I am inserting the welding symbols on a table manually (in the sense that I did not use the welding application in part modeling).
I have a problem with continuous angle welding:
popping up the "fillet-size" option (i.e. cord size) the software allows me to enter only a numerical value.
how do I indicate what size it is (a or z)?
Thank you.
Palo
I am inserting the welding symbols on a table manually (in the sense that I did not use the welding application in part modeling).
I have a problem with continuous angle welding:
popping up the "fillet-size" option (i.e. cord size) the software allows me to enter only a numerical value.
how do I indicate what size it is (a or z)?
Thank you.
Palo