Situation fold odds and development

[Morwen]

Bye to all,
I have a profile with a fold greater than 106° and a lower than 74° inside,
the upper one measured horizontally makes 55mm, in oblique 56.6 and in development 52mm and thus seems correct
while the lower horizontal one is from 57.5mm, in oblique does 57.3? and in development 53.4? and here the accounts do not come back...
the profile in question is in iron sp. 2.5mm, the quotas are all taken from external folds.

allego pdf file and idw(2010) of the table for greater clarity: View attachment 40877

 

[gil]

the link does not work :frown:

 

[Morwen]

I had not read the instructions:redface:
Now it should work. . . .

 

[il teo]

Good morning.
If I understood correctly, do not return the quotas in development and sight?
Well, but they are comparing different odds: the fold line is corresponding to the quarry, not to the esthene (in practice you should quota the inner curve center of each fold. supra comes in a way because the folds have the same meaning, under they have opposite meaning.
I hope I've explained