size graphic

[pompeo79]

Bye to all,
I asked if it exists and how you invoke a command similar to the "graphic cut" of inventor, which allows you when you make a sketch inside a solid, to temporarily remove the portion between the view and the sketch plane, to see what you draw.

Thank you!

 

[Be_on_edge]

Bye to all,
I asked if it exists and how you invoke a command similar to the "graphic cut" of inventor, which allows you when you make a sketch inside a solid, to temporarily remove the portion between the view and the sketch plane, to see what you draw.

Thank you!

the command is called "set-up" in the "cut" group of the "view" tab.
you have to set offsets for cutting depths, 0 corresponds to the sketch plan.

Hi.

 

[pompeo79]

Thank you frankly, you were very kind!