slow design 2d

[abro]

Good morning
I often work on the 2d model of the draft environment, I carry out trivial designs but it is slow to die sometimes
pass seconds to select a line and update the panel select ,
But is it normal?

 

[stevie]

I don't think...

hardware configuration and software release?

 

[abro]

12th gen intel(r) core(tm) i7-12700k 3.60 ghz
installed ram 32,0 gb (31.8 gb usable)
type 64-bit operating system, processor based on x64
edition windows 11 pro
version 23h2
solidedge 2023 v 2210.0009

 

[Be_on_edge]

you have not specified the video card, which is fundamental for the management of the graphics.

 

[abro]

 

[infallibile_GF]

beautiful pc monster, so the fault is not hardware

 

[abro]

within if there is no way to speed up the selection, for some reason it seems that when I go to select the elements the panel selects and then property puts a tot to identify the elements

 

[Be_on_edge]

I would proceed by step with this sequence (after each step make a test, the steps should be executed with solid edge closed)

• upgrade solid edge to the update 0013, you seem to be still at the update 0009
• Driver update video card
• %temp% folder cleaning
• restore solid edge settings to default

if all this does not give the hoped results we will discuss

 

[abro]

hi I performed half the operations, driver update video card and cleaning file temp
and the situation has improved, update if unfortunately we have not yet purchased the r24 so I think I can not update it.
I ask instead if the solid edge restore to the default is not a bit too, considering that I have
saved many custom settings known text blocks etc?

I also ask if there are fast courses for drawing 2d because I hypothesize, having always used other cads, some operations can not be so macchinose

 

[Be_on_edge]

hi I performed half the operations, driver update video card and cleaning file temp
and the situation has improved, update if unfortunately we have not yet purchased the r24 so I think I can not update it.
I ask instead if the solid edge restore to the default is not a bit too, considering that I have
saved many custom settings known text blocks etc?

I also ask if there are fast courses for drawing 2d because I hypothesize, having always used other cads, some operations can not be so macchinose

before doing the restore you can make a backup of the settings