software cold molding

[reb_bl]

good morning to all, as from object I would like to hear your opinions, opinions and suggestions on calculation software for the deformation of the tablets to get a certain finished piece in cold molding.
basically a sort of fem for cold molding.
Thank you all. :finger:

 

[SHIREN]

good morning to all, as from object I would like to hear your opinions, opinions and suggestions on calculation software for the deformation of the tablets to get a certain finished piece in cold molding.
basically a sort of fem for cold molding.
Thank you all. :finger:

Hi.
Thank you for posting your probes. in this forum
But
I would say try in the appropriate area (fem etc.)
from these parts very likely that we only do the "sporty" job
I move the discussion in the general forum cae-fem etc.
Thank you very much

 

[MacGG]

Hello reb_bl,

for cold sprinkling, use msc.marc or better, the product that uses such solutor and is dedicated to molding, which is simufact.

Hi.

♪

 

[reb_bl]

Hello reb_bl,

for cold sprinkling, use msc.marc or better, the product that uses such solutor and is dedicated to molding, which is simufact.

Hi.

♪

hi macgg I looked at the site a little, I will try to contact a dealer to deepen better, you know what band we are (in the mid or top sense of the range)?