solid edge st9 - 2 piece simulation

[MarianoD]

Hello everyone,
I write to you because I am facing a problem that I hope is not too complex.

work in a company where small (or even microscopic) components regarding the telecommunications world,
I would therefore need to make simulations between two pieces that must be united, (unfortunately I cannot show them) I can summarize with :

a full cylindrical male that has to enter into a female with drought blades inside that bend to the passage of this, so I would need to know how to simulate the insertion of this cylinder and the consequent deformation of the female by contact.

with solid edge tutorials and help I couldn't come to the head of this problem because I find only thermal simulations or single pieces, I hope you can help me.

I also have ansys but I would prefer to learn this on solid edge as it is the program I use most.

thanks in advance,
Marian

 

[Be_on_edge]

Hi.

do you need simulation to dimension these "labels" or for a presentation?

or: Do you know their behavior or do you have to dimensional them so that they behave in a certain way?

Hi.

 

[MarianoD]

Hi.

do you need simulation to dimension these "labels" or for a presentation?

or: Do you know their behavior or do you have to dimensional them so that they behave in a certain way?

Hi.

Hello, thank you for the answer.

I need the simulation exactly to figure out how they behave, you've got the point

 

[MarianoD]

Hi.

do you need simulation to dimension these "labels" or for a presentation?

or: Do you know their behavior or do you have to dimensional them so that they behave in a certain way?

Hi.

Hello, I'm sorry about the double post.. I am trying to do tests with the automatic connection "no penetration but nothing to do, also force constraints etc. They don't seem to be doing well.

for now I am trying to understand the operation on a cylinder that pushes to collide with a small thickness perpendicular sheet to test the flexibility of the sheet but I just can't make it work