solid interaction

[feurich]

Hello everyone, I am using solidworks 2102.

I have created a hollow structure with two helids that rotate differently, the goal is to raise a disk from a lower wound up to above.

(substantially, you rely on merendine distributors, with the helid that turns and drops the product).

I set engines on the helid trees, put the disk in the middle, but when the simulation starts the helids turn and the disk remains there.

how can solids interact with each other, and therefore in this case, be dragged?

♪

 

[re_solidworks]

Hello everyone, I am using solidworks 2102.

I have created a hollow structure with two helids that rotate differently, the goal is to raise a disk from a lower wound up to above.

(substantially, you rely on merendine distributors, with the helid that turns and drops the product).

I set engines on the helid trees, put the disk in the middle, but when the simulation starts the helids turn and the disk remains there.

how can solids interact with each other, and therefore in this case, be dragged?

♪

You have to go on "movement analysis" and to do so you have to have premium nua. then activate the "contact" between the parties that interest you.

p.s.
you are ahead with the version of swx! ! !

 

[marcof]

Hello everyone, I am using solidworks 2102.

you are ahead with the version of swx! ! !

is a version that reads thought, but must have a pc of 2102 with the brain interface, for what can not do simulation. not "without" commands:smile:

 

[feurich]

You have to go on "movement analysis" and to do so you have to have premium nua. then activate the "contact" between the parties that interest you.

p.s.
you are ahead with the version of swx! ! !

yeaaaaaaaaaaaaah, you must have windows 100 though and a ram peel at least!

Anyway! the premium I have it, I set engines and also contact (which is the icon the one with drawn on the cam, no? ) But when I spin the engines the disk always stays there...

Can you use a photo? that in case the place...

 

[feurich]

solved! That was it, thank you!

I also got out the notice that I had to set the weight! :finger: