solid transparency save in stp

[Simonnvrg]

Hi.
I just went to the r24 version of catia and I have the following problem, when I save files in stp and then I go to open it I see the solid in transparency even if in the catpart it was not
How can I avoid that?
Thank you.

 

[gianni55]

I don't have r24, so I can't check.

do some tests by examining that the step options are set identically in the r24 and the previous one you used, or if in the r24 there is an additional parameter (this is in import and export)

parameters found in:

menu/instruments/options/general/compatibility/step

verification to use the protocol ap 214 iso

Let me know.

Hi.

years ago

 

[Simonnvrg]

I checked the options and are the same as the version I used previously(r19), and the protocol is ap 214 iso, in fact the colors keep them the same the problem remains on the transparency of solids
can it be linked to some setting of the designer that generates files?

 

[gianni55]

Not usually,

to be sure to reopen the step with the r19

or select the part or the product, go to property/graphics put the check mark in property (transparency inheritance) and put everything to 0

Let me know.

Hi.

years ago

 

[Simonnvrg]

if I open the step with the r19 the transparency is not there, opening it with the r24 instead remains in transparency only the first feature(prism) and the following remain accurate, in fact if I make the passage from you indicated(selections the part or the product, go into property/graphics put the check mark in property) the transparency is already to 0

 

[gianni55]

I don't understand why 24 acts like this...

However it is not enough that it is at 0, you also have to put the check mark and only then updates the transparency.