solidworks certifications

[Roberto96]

Good evening.
I am passionate about 3d modeling and use solidworks from high school, definitely not at an advanced level, and I would like to address my future work in this area. I do not currently work with solidworks so I can not put it on the cv as a work experience and therefore I thought to take the certifications of solidworks, also because I happened that in the job interviews they asked me if I had any certification or not.
I downloaded the software to carry out the exams and tried the cswa and cswp segment 1, and, overcome both without difficulty, I also carried out the respective exams, so I got the cswa certification and passed the first of the three exams of the cswp.
Now, since on their software there are no samples for the other 2 cswp exams, any of you, if you might have run the exams or know what it is, could you help me understand what is contained in these other 2 exams? so I could adjust on or

 

[MassiVonWeizen]

correct me if I say a cow, you miss these two cswp exams:
segment 2: (40 minutes)

• configuration creation from another configuration
• configuration change
• mass property
• modification of the characteristics of an existing part of solidworks

segment 3: (80 minutes)

• creation of a joint
• adding parts to a set
• collision detection while moving part to a set
• mating
• replacing one part with another in one set
• creation of a coordinate system
• use of a coordinate system to perform analysis of mass properties

all the steps are explained in the tutorials you should have done.
If you say you use solid from the top like creating a set, how to make a coupling, how to detect the mass you should know how to do it.
if you have problems on one of the steps you help

 

[Roberto96]

These two are the exams I miss.
Yes, I use solidworks from the top but not working, I use it because I like to draw.
with regard to axiemi and couplings I used both fixed and mobile within a certain range given by an angle or a quota in mm (or other unit of measurement)
What I've never seen about axiemi is the collision detection when moving parts into a set.
instead the part of the calculation of the mass I know how to use it and has been asked several times during the cswa examination and also in the first segment cswp.
instead regarding the second segment cswp I recently started to see the configurations mainly following videos on youtube. for example I used them in the design of a screw and had made several configurations regarding the diameter of a screw and then sub-configurations for the length.
But I would like to know if there is someone who has already done the exam so that I can advise and tell me if these knowledge is enough to pass it or if I have to do more practice

 

[MassiVonWeizen]

What I've never seen about axiemi is the collision detection when moving parts into a set.

but if you have opened a discussion on this https://www.cad3d.it/forum1/threads/dinamica-fisica-assiemi.57995/#post-454652

 

[Roberto96]

I opened it because it was the first time I tried to detect the collision between objects