solidworks routing, wiring designs

[Mauro56]

good morning to all, I am mauro and use a solidworks 2015 for mechanical design. now I'm trying with the electric routing that I learned via network tutorials. I can install cables on the axieme, with its connectors, and get the installed cable 3d axieme. the difficulties arise on the 2d design for the realization of the wiring, which I can not get in a suitable form to be used in production. I attach two screenshots of the full cable of connectors that I can get in 3d and its 2d design that should report the directions of realization and that does not seem suitable for purpose. If anyone can help me by pointing out some tutorials or other means of update, I would be grateful.
thanks for the interest

 

[MassiVonWeizen]

drawing 2d that should report the indications of realization and that does not seem suitable for the purpose.

If you explain what should be the indications you can give an indication on how to fix the model.

Even the images try to make them better because in the drawing you do not read anything so low is the resolution. do not need to put them in a pdf you can well attach them as single images

 

[Mauro56]

Thank you for your interest. As a concept the wiring design requires me to allow a supplier to be able to realize each cable that will constitute the wiring according to the indications contained in the drawing. Obviously this is a general concept. in the past I have realized the designs of the wiring cables in autocad according to the example of the attached design (I hope to see well), but I am not binding on the graphics as the possibility of understanding the necessary indications for the realization of the cable: Connectors, cable diameter, length and connecting pins on connectors.

 

[MassiVonWeizen]

are properties that you have to fill out within the various parts.
I have never used routing, but the basic concept of the parts is always that: you define the properties you want to see and then call them in the drawing with the material table or with the notes

 

[Mauro56]

Thank you for the answer, I try to go deeper with the properties of routing details