souls for melting in the ground

[Ing Italy]

Hello.

my doubt concerns the execution of internal gorges to holes: can these be carried out thanks to their positive realization on the soul or being too thin and therefore fragile it must always be obtained after the mu with an internal turning, baring or with disc cutter for interior? I ask this because in different university tasks I happened to see that the internal throats were not realized directly from the fusion but obtained from the mu but no one has ever explained why then I imagined that you should do too thin protrusions, that therefore could not resist, on the soul, is it correct?

 

[Il marangon]

How big is the throat? can be reached by mu?

there are gorges as in the turbine cases that would not be feasible with mu but only with souls on earth, other times it is preferable to make them by milling for greater precision or not to risk that remains of the earth in the throat or inside the fusion.

you have to evaluate case by case

 

[Ing Italy]

the throat has height 3mm.thanks for the answer, in fact this I think it can be the case in which it agrees to realize it with mu because I would risk to ruin the soul being the very thin detail.ciao and thank you!

 

[SHIREN]

the throat has height 3mm.thanks for the answer, in fact this I think it can be the case in which it agrees to realize it with mu because I would risk to ruin the soul being the very thin detail.ciao and thank you!

Hi.
you have to evaluate the design
you can also gorge from three mm in fusion with shell core
Thank you very much