Giacomanu
Guest
Hello everyone, I have a small problem, I am in sketch mode and I am projecting lines of a solid, to create another solid, but when I find myself projecting curves (which are actually circles, but being cut oblique, become spline) I can no longer find the center of this spline, which I would need to make holes.
I wrote really bad, however the juice is if there is a command that recognizes the center of a spline, which derives from the projection of a circle.
I hope I've been a little clearer, and you can help me.
Hello and thank you
I wrote really bad, however the juice is if there is a command that recognizes the center of a spline, which derives from the projection of a circle.
I hope I've been a little clearer, and you can help me.
Hello and thank you