16_alex_85
Guest
Hello everyone, I looked a bit on the forum, but I did not find answers to my question. I have performed a total in caia v5 of which I would like to perform a static analysis with the same program, but I have difficulties to carry out this analysis on a total (on single parts nn I have problems). Basically it is a number of parts connected through bolts. I would like to ask you what kind of constraints to use. in assembly I use mostly constraints of coincidence of the axes, but in the analysis environment what kind of constraint I must consider. Another problem is that some parts act as a simple pendulum and I don't know how to bind them.
I only need a few tips on where to find manuals.
thanks for the attention.
p.s. I attach an image of how the overall is constituted, considering that the rods are held together by bolts.
I only need a few tips on where to find manuals.
thanks for the attention.
p.s. I attach an image of how the overall is constituted, considering that the rods are held together by bolts.
