istoria
Guest
Good morning!
I am using adams/insight software for the thesis and should do a study on how cinematic outputs vary if statistically vary the position and orientation of the joints (specifically, position and orientation of a cylindrical joint).
in adams/view I can define the variables by going into the "move" of the bond and parameterizing the coordinates; I carry everything in adams/insight, add these variables to the factors and launch the experiment. adams/insight leaves and does all the simulations. . .simplely by not changing the parameters, i.e. even if in the doe matrix it shows me all the variables that take different values when then simulates the system always has the same values as these variables (equal to the initial values). ..I would be very grateful to those who know how to give me some indication on how to solve the problem...also because the time tightens!! Thank you.
I am using adams/insight software for the thesis and should do a study on how cinematic outputs vary if statistically vary the position and orientation of the joints (specifically, position and orientation of a cylindrical joint).
in adams/view I can define the variables by going into the "move" of the bond and parameterizing the coordinates; I carry everything in adams/insight, add these variables to the factors and launch the experiment. adams/insight leaves and does all the simulations. . .simplely by not changing the parameters, i.e. even if in the doe matrix it shows me all the variables that take different values when then simulates the system always has the same values as these variables (equal to the initial values). ..I would be very grateful to those who know how to give me some indication on how to solve the problem...also because the time tightens!! Thank you.