enrico1979
Guest
hello to all boys
I realized that the diagram of the moment (using the simc command accompanied by a number, depending on the type of element chosen ) is in reverse apdl compared to what would be achieved by respecting the convection (enterprise learning) according to which the diagram of the moment should be traced in the direction of the weave fibers.
even if the problem raised is absolutely irrelevant for the purposes of structural calculation, since the butterfly of the moment by date straight section of beam induces two maximum voltages equal in module, with one compression and the other traction (i.e. for the calculation of the voltage I need to know only the value of the module of the moment and therefore a reversed diagram would not cause to error), I asked if someone had found the same problemuccio, and in the case.
What do you say? ? ?
Let me know and
bye bye
I realized that the diagram of the moment (using the simc command accompanied by a number, depending on the type of element chosen ) is in reverse apdl compared to what would be achieved by respecting the convection (enterprise learning) according to which the diagram of the moment should be traced in the direction of the weave fibers.
even if the problem raised is absolutely irrelevant for the purposes of structural calculation, since the butterfly of the moment by date straight section of beam induces two maximum voltages equal in module, with one compression and the other traction (i.e. for the calculation of the voltage I need to know only the value of the module of the moment and therefore a reversed diagram would not cause to error), I asked if someone had found the same problemuccio, and in the case.
What do you say? ? ?
Let me know and
bye bye