structural members and excel table

[reggio]

hello, I was a bit inca########################################################################################################################################################################################################################################################
then I read the post "new policies of updates?" and I finally burst:frown:

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
cmq, I write because I tried without success to create a table on a part made with structural members: the tab is created but the dimensions (of the sketches) that are usually reported in the tab and that therefore are editable, in this case there are not: (certain, it is not an extrusion but a sketch, blah, blah, but caz### sw is a work tool or is it a game? - Excuse me.

have you faced the problem otherwise?
In practice I want to fly this part also through a sheet of excel.. .

Good Sunday

 

[Gabryn]

I tried without success to create a table on a part made with structural members: the tab is created but the size (of the sketches) that are usually reported in the tab and therefore are editable, in this case there are no

from what he said:
1- in an empty column carry the name of the quota you want to fly and below write the various values
2- or once you are in the table and below you see the model: clikki on the sketch share and should automatically add the column
referred to the item chosen.

Hi.
Gabriele

 

[re_solidworks]

hello, I was a bit inca########################################################################################################################################################################################################################################################
then I read the post "new policies of updates?" and I finally burst:frown:

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
cmq, I write because I tried without success to create a table on a part made with structural members: the tab is created but the dimensions (of the sketches) that are usually reported in the tab and that therefore are editable, in this case there are not: (certain, it is not an extrusion but a sketch, blah, blah, but caz### sw is a work tool or is it a game? - Excuse me.

have you faced the problem otherwise?
In practice I want to fly this part also through a sheet of excel.. .

Good Sunday

to me it works quietly, exactly how do you try to configure? because if you're doing it with the member section you're doing a conceptually wrong operation, since that section takes behind the section chart.
with regard to the sketch of the axes of the looms fused to perfection.
for the back of the network file connection...according to me you should radiate the obstacle (not only with swx, but with all software) creating an equal network unit on all pcs connected to the same network path.

 

[reggio]

from what he said:
1- in an empty column carry the name of the quota you want to fly and below write the various values
2- or once you are in the table and below you see the model: clikki on the sketch share and should automatically add the column
referred to the item chosen.

Hi.
Gabriele

You're right, in this case it works (usually charging them automatically), but I can't get the repeats I want to fly into the table. . :

to me it works quietly, exactly how do you try to configure? because if you're doing it with the member section you're doing a conceptually wrong operation, since that section takes behind the section chart.
with regard to the sketch of the axes of the looms fused to perfection.
for the back of the network file connection...according to me you should radiate the obstacle (not only with swx, but with all software) creating an equal network unit on all pcs connected to the same network path.

Hi, I don't change the member, I'd like to fly the amount of repetitions... but as I wrote above, in this case I can not (in a solid instead yes...)
fault of the member?

ps: I tried to explain more about the network problem here http://www.cad3d.it/forum1/showpost.php?p=154419&postcount=15