studio con solidworks simulation

[zakstevenson]

Good morning to all, I have to carry out a study with solidworks simulation, I have a motor shaft with forces applied in the crank pins, and I have to get the forces discharged on the counter supports... I try to carry out it but I can not get these blessed forces. . .
I used the static study, I applied 4 constraints in the counter media, I applied 4 remote forces on the crank pins, I create the mesh, I carry out the study of stress and deformation. but I do not understand from where I echo the forces on the supports.
Can anyone help me?

This would be my engine tree:

 

[SolidUser]

Good morning to all, I have to carry out a study with solidworks simulation, I have a motor shaft with forces applied in the crank pins, and I have to get the forces discharged on the counter supports... I try to carry out it but I can not get these blessed forces. . .
I used the static study, I applied 4 constraints in the counter media, I applied 4 remote forces on the crank pins, I create the mesh, I carry out the study of stress and deformation. but I do not understand from where I echo the forces on the supports.
Can anyone help me?

This would be my engine tree:

the correct section is This is whatI ask you have moderators to move it.

 

[Swarzy]

Hello zakstevenson,

If we give a good analysis setting, to obtain binding reactions (I believe you need this) follow the instructions on the linked page:
http://help.solidworks.com/2011/italian/solidworks/cworks/legacyhelp/simulation/dialog_box_help/idh_help_reaction_force.html?id=39c257a57514437e99dc133a9ec5cffd#pg0Giornata buona, cookers.