study of movement

[enrico.losio]

Good morning to all, I tried and tried... but I couldn't, honestly I don't even know if you can.
I explain better, circular and linear vibrator project, I would need to verify the behavior of a certain component that flows on the outputs created ad hoc, so check that if this is in a certain position continues towards the exit, vice versa falls into the cup, I saw that there is "movement study" to which it is possible to apply gravity, but after having handed out a little I did not finish anything, someone uses it? Thanks for the answers.

 

[teseo]

then as I have already said many times the simulation piece is not as simple as the dassault makes you believe, indeed..
To get a little cuffed, it means to lose us behind whole days... .
I have the basic package and there is no way that I know a motor that could simulate a vibrator... you could invent a circular motor with an oscillatory movement to try to simulate your vibrator....
but I repeat it is not what can be resolved in some hours....
In my opinion you should give a linear movement to your piece along the final track of the vibrator with a low speed and see what effect it does then change step by step adding constraints compnetrations etc..
I repeat it is not an easy thing, set your model....
What package do you have?
Hi.

 

[Fulvio Romano]

I think it's more stuff than sw.
a multibody simulation that gives credible results I think costs an order of magnitude more than a prototype in this case.

 

[enrico.losio]

I have the basic package and there is at least no way that I know an engine that could simulate a vibrator. . .

In fact, I don't want to simulate a vibrator, I just want to understand how a particular would behave to which a force of gravity applied according to certain constraints such as the sliding plan on which it passes considering its centerpiece... I don't know if I can explain! !

 

[teseo]

You can do that to me....

 

[teseo]

you explained very well...the answer unfortunately does not know to tell you about two feet, if you care about the thing you owe as first thing to follow the simulation tutorials and search all the material you can find on the internet.
then you hit our head not little until the purpose; otherwise you take a small course on simulation and go out with your head not broken and definitely in a short time.
I say this because I think such a complex tool cannot, at least for me, be used without a learning course. You make a lot of time.
Hi.

 

[strudeldemele]

Good morning to all,
I know a little linear and circular vibrators, the 4 companies I know are artisans, designers do not make simulations and historical knowledge counts much more than theoretical, even x is in the reality of a vibrator add a casino of calculating factors (empirically) and not that only practice can give you.
I know that from the initial project many ritocchi were made in operation to have a good result.

Hi.