superfice in tangenza

[mamobono]

Hello everyone
I created a simple handle
the shovel was built to be in tg with the body
the surfaces of construction are tg but when solidifying here is that for half tg there is a curve of union of the surfaces that makes no sense

: why does the mirror function not autonate when you change the feature that mirrors?
I set up an employee (e.g. curves) , is there any other settling that is opposed to this and that makes me actually independent features ?


x wf4 file attached photo and prt

I thank in advance who solves the problem

 

[folle76]

As for the merging curve, I honestly did not understand what you mean. Maybe try to post an image.
to mirror the curve and get an dependent mirror you do not have to select the feature from the tree and make mirror: you must select the curve with the geometry filter and then mirror it. in this way you get an employee feature.

 

[mamobono]

Thank you for the answer:
1
As for the merging curve, I honestly did not understand what you mean. Maybe try to post an image.
I meant the curve between the cylinder and the horizontal surface.
I expected it to be a curve on the plane instead, see 3d the pdf image is unclear, it is a strange curve.

2
to mirror the curve and get an dependent mirror you do not have to select the feature from the tree and make mirror: you must select the curve with the geometry filter and then mirror it. in this way you get an employee feature.
I'll try

Thank you.