surface topographic revit

[revit2011]

Hello everyone, I am new to the forum, I write as a calabria reggio.
I need to ask you a few questions:
I have to return in 3d a listed relief made by the geometries and apply on this of the road levelettes.
I have revit2011 recently and still have not arrived at these levels.
the work must be done with a certain urgency so please if possible to answer me as soon as possible.
thanks in advance

 

[Tristan]

avoid writing in case, thanks :wink:

Hello everyone, I am new to the forum,
I have to return in 3d a listed relief made by the geometries and apply on this of the road levelettes.

street level on revit? I see it hard... do you know that revit is an architectural design software?

 

[revit2011]

I know that but to create the topographic sup?
Can't you do anything about the levellings?

 

[revit2011]

what do you recommend to me?

 

[gfrank]

I suggest you read the forum discussions about the topic (use the "search" button on the top right of the revit forum).

in general the management of the topographic surface is carried out for "quota points" that in the return are "united" through the level curves.
the command that approaches the levelets is "leveled region", which allows to implement in successive phases, drafts and reports.

for the return of a relief it is appropriate that the same is performed in a dwg file, to be imported then in revit.