surface

[blubossa]

Hi.
I have to realize a particular with a shape that a bit strange... I sketched the curves of reference that I should connect with surfaces and then solidify. . Now the problem is that I don't know how to get these curves. .

I attach files, which we hope will understand. .

Thank you.
bb

 

[enrico1979]

I do not understand if the final rectangle should be connected, cmq in any way I would make half curves (as far as I can see it seems that the component is symmetric).
then if on the lower side you have to close it all uses the fill command (to collect the pre-centered curves uses the blend obviously).
then mirrors and solidifies.
I believe there are further problems (even if there was a connection between the thermal rectangle)
I hope I've helped you.

Hi.