sweep of solid or sweep with profilo ??

[fox76]

I've been practicing a bigooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooo

I have to make a sweep cut on a cylinder with a helical path. With solidworks 2008 I could safely do the sketch of the path (a propeller), I created my normal cutting profile at the 2 clik path and it was done. with sldwrks 2009 x63 sp 3 there is no verse except that with "sweep of solid" !!!
I or Has anyone forgotten to inform me of any changes? ? ? ?

 

[re_solidworks]

do not do it if you do not update to sp 4.0 or if you do not regress to sp. 2.0. is a problem related to that 64-bit service pack. to achieve the problem you may use the surfaces, but you should put the service pack 4.0 and so on.

Bye.

 

[fox76]

I think you're right. I'll install the sp 4.

Thank you.