tabella prt e drw

[blubossa]

Bye to all,
a big project and I need to check if I miss the food.
I would like to insert the general axieme and then create a table where I view the code part and close the relative drw, if the field is not present it must be empty.

I don't have the pallidest idea if this is feasible, or not......................:redface:

Thank you.
bb

 

[Parametric_Ozzy]

Bye to all,
a big project and I need to check if I miss the food.
I would like to insert the general axieme and then create a table where I view the code part and close the relative drw, if the field is not present it must be empty.

I don't have the pallidest idea if this is feasible, or not......................:redface:

Thank you.
bb

automatic is not possible.
also because a component or a set can have x boards, for that required by force of a pdm.
you can do it manually.

 

[blubossa]

I had imagined... but I was hoping for some good news:frown:

bb

 

[Parametric_Ozzy]

I had imagined... but I was hoping for some good news:frown:

bb

Don't get down, put a colon in ft where you call the 3d table parameter, as well as the code...